Filters
Interlayer Adhesion of Coating System in Analogue and Digital Printing Technologies Formed on Lightweight Honeycomb Furniture Panels
This article concerns research into the influence of the energy dose distributed by UV lamps on selected parameters of varnish coatings formed during the varnishing process of lightweight cellular panels. The lightweight cellular board used in the study was made according to an innovative solution. The surface finishing of the boards was carried out using the roller method in combination with digital and analogue printing under industrial conditions. Contact angle measurements of the obtained varnish coatings were carried out, from which the surface free energy was calculated. In addition, interlayer adhesion was assessed by pull-off tests. Irrespective of the radiation dose, higher contact angle values (54.3–89.9°) were recorded for the last two applied layers (base coat 2 and base coat 3) than for the other coatings (39.6–64.1°). For all systems tested, the γsp component showed lower values (2.25–28.99 mJ/m2) than γsd (28.66–32.80 mJ/m2). The adhesion test results ranged from 0.5 to 0.9 MPa, although with varying types of delamination. Based on the test results, the most favourable variants from the furniture manufacturer’s point of view were selected that provided the desired level of adhesion, in which cohesive damage located within the substrate (A) predominated.
Adhesion of varnish coatings as a background for analogue and digital printing technologies
In analogue and digital printing technologies, from 3 up to 12 layers of lacquer products are applied. Technological parameters significantly influence the adhesion in the coating system. This article refers to the analysis of the influence of selected technological parameters, such as the number of layers, energy doses distributed by the radiators, and line speed, on the topography and adhesion of varnish coatings formed in the process of varnishing with rollers and UV-curing systems. The appropriately prepared surface can be used as a background layer for the analogue and digital printing technology. Manufacturers must adapt the production process to the particular varnish to obtain finished products with the best possible performance properties. The state of surface free energy and finally adhesion can be assessed by theoretically determining the possibility of an adhesive bonding between the product and the substrate, taking into account the assumptions of the adsorption theory of adhesion and measurement of the contact angle (Θ). An experimental confirmation of adhesion measurements included removing the coatings from the substrate via stamps glued to the coating.