Filters
The Effect of Treatment with Fire Retardant on Properties of Birch Veneer and Manufactured Fire-Resistant Plywood
The tea leaves as a filler for uf resin plywood production
The addition of green tea leaves fractions < 0.315 mm as afiller to urea-formaldehyde resin to reduction of emission of formaldehyde from three-layer birch plywood was investigated. Moreover, other properties such as bonding quality and water resistance of plywood were investigated. It was found that green tea had an ability to absorb formaldehyde. This phenomenon was caused by phenolic compounds contained in green tea leaves. The addition of green tea in the amount of 20% and 25% resulted in a decrease in formaldehyde emission fromplywood comparing to the reference sample. Thebonding quality test showed that the addition of tea leaves as a filler did not affect thestrength properties of the tested bond lines.
The effect of urea-formaldehyde adhesive modification with propylamine on the properties of manufactured plywood
Modified Buckwheat Husk as a Filler for Urea–Formaldehyde Resin in Plywood Production
The aim of the presented research was to determine the suitability of both non-modified and modified buckwheat husk (BH) as a filler for urea–formaldehyde adhesive in plywood production. The effect of two modification methods, acetylation and silanization, was investigated. Infrared spectroscopy outcomes confirmed that both acetylation and silanization of the filler had occurred. Based on the results, it was found that the introduction of BH had a significant effect on both the adhesive properties and the characteristics of the manufactured plywood. The application of non-modified husks led to a reduction in viscosity and an extension of the gelation time, and the produced plywood boards were characterized by reduced bonding quality and increased delamination. Modification of the husk surface by acetylation and silanization with 3-aminopropyltriethoxysilane contributed to the noticeable improvement in the resin properties. On the other hand, the improvement in plywood properties, consisting of the increase in bonding quality and reduced delamination, was observed only in the case of the silanized husk. Furthermore, the use of non-modified and acetylated husk did not significantly influence the formaldehyde emission. The reduction in the investigated emission of formaldehyde was observed only in the case of variants containing 15 and 20% of silanized buckwheat husk.
The Application of Various Bark Species as a Fillers for UF Resin in Plywood Manufacturing
The aim of the presented study was to apply various bark species (birch, beech, maple, pine and spruce) as fillers for urea-formaldehyde (UF) resin in three-layer plywood manufacturing. For this purpose, all types of bark were ground and added to the adhesive mixture. The resultant plywood was subjected to investigations of the following: tensile strength, modulus of elasticity (MOE), bending strength (MOR) and formaldehyde emission. The results indicate a reduction in the tensile strength. Moreover, the lack of significant improvement in strength parameters can be explained by too high a load of the filler (20 wt%). In the case of formaldehyde emissions, a reduction was observed for birch (B-1), beech (B-2), maple (B-3) and pine bark (B-4). In addition, an increase in the emission of formaldehyde was recorded only for spruce bark.