Simple item page
 

Change of cutting parameters and their influence on the particle size distribution when sanding thermally modified material

cris.virtual.author-orcid#PLACEHOLDER_PARENT_METADATA_VALUE#
cris.virtual.author-orcid#PLACEHOLDER_PARENT_METADATA_VALUE#
cris.virtual.author-orcid#PLACEHOLDER_PARENT_METADATA_VALUE#
cris.virtual.author-orcid0000-0003-4957-1042
cris.virtual.author-orcid#PLACEHOLDER_PARENT_METADATA_VALUE#
cris.virtualsource.author-orcid#PLACEHOLDER_PARENT_METADATA_VALUE#
cris.virtualsource.author-orcid#PLACEHOLDER_PARENT_METADATA_VALUE#
cris.virtualsource.author-orcid#PLACEHOLDER_PARENT_METADATA_VALUE#
cris.virtualsource.author-orciddb2ff8e2-8bc0-4fd4-bbc1-07ba3ca94ccf
cris.virtualsource.author-orcid#PLACEHOLDER_PARENT_METADATA_VALUE#
dc.abstract.enThe research was focused on wood dust generated during the sanding of native pine wood and two types of heat-treated pine wood (Thermo-S and Thermo-D). The aim of the research was to assess the effect of feed speed and type of workpiece on the generation of wood dust. The experiment was performed on a Buldog 7 wide belt sander. The dust generated during sanding was subjected to particle size analysis by means of Retsch AS 200-digit apparatus on a set of sieves with mesh sizes 1000, 500, 250 and 100 μm. The laser particle sizer Analysette 22 Microtec Plus was used to determine the size distribution of dust particles smaller than 100 μm. The obtained results showed the influence of thermal modification and feed speed on the generation of wood dust. The heat-treated wood produces more fine dust than native wood. The higher the modification temperature, the higher the fine dust content. It has been found that the fine dust content increases with decreasing feed speed.
dc.affiliationWydział Leśny i Technologii Drewna
dc.affiliation.instituteKatedra Meblarstwa
dc.contributor.authorHanincová, Lud'ka
dc.contributor.authorVráblik, Michal
dc.contributor.authorKopecký, Zdeněk
dc.contributor.authorNovák, Vit
dc.contributor.authorRogoziński, Tomasz
dc.date.access2026-01-12
dc.date.accessioned2026-01-12T13:52:04Z
dc.date.available2026-01-12T13:52:04Z
dc.date.copyright2022-12
dc.date.issued2022
dc.description.accesstimeat_publication
dc.description.bibliographyil., bibliogr.
dc.description.financepublication_nocost
dc.description.financecost0,00
dc.description.points5
dc.description.versionfinal_published
dc.description.volume13 (1)
dc.identifier.eissn1339-8350
dc.identifier.issn2453-904X
dc.identifier.urihttps://sciencerep.up.poznan.pl/handle/item/6749
dc.identifier.weblinkhttps://kod.tuzvo.sk/sk/casopis-katedry
dc.languageen
dc.relation.ispartofTrieskové a beztrieskové obrábanie dreva
dc.relation.pages13-18
dc.rightsOther
dc.sciencecloudnosend
dc.share.typeOTHER
dc.subject.enheat-treated wood
dc.subject.ensanding
dc.subject.endustiness
dc.subject.ensieve analysis
dc.subject.enlaser particle sizer
dc.titleChange of cutting parameters and their influence on the particle size distribution when sanding thermally modified material
dc.typeJournalArticle
dspace.entity.typePublication